Cisco 7975G Software Manual page 90

Device Configuration Menu
Table 4-13 Media Configuration Menu Options (continued)
Option
Recording Tone
Duration
Wideband Headset
Enterprise Advertise
G.722 Codec
Device Advertise G.722
Codec
Cisco Unified IP Phone 7975G Administration Guide for Cisco Unified Communications Manager 7.0 (SCCP and SIP)
4-22
Description
Indicates the length of time in milliseconds that
the beep tone plays.
If the value you configure here is less than one
third the interval, then this value overrides the
default provided by the Network Locale.
Range: 0 to 3000
Note For some Network Locales that use a
complex cadence, this setting applies
only to the first beep tone.
See also: Recording Tone
Indicates whether wideband is enabled or
disabled for the headset.
Default: Disabled
Enables/disables Cisco Unified IP Phones to
advertise the G.722 codec to Cisco Unified
Communications Manager. If enabled (default),
and if each endpoint in the attempted call supports
G.722 in its capabilities set, Cisco Unified
Communications Manager will choose G.722
for the call.
When a phone is registered with a Cisco
Note
Unified Communications Manager that
does not support this setting, the default
is "Disabled."
Allows you to override the Enterprise Advertise
G.722 Codec on a per-phone basis.
The default is "Use System Default," which
means the value configured for the Enterprise
Advertise G.722 Codec parameter gets used.
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
To Change
From Cisco Unified Communications Manager
Administration, choose Device > Phone >
Phone Configuration.
If Wideband Headset UI Control is enabled, you
or the user can use the phone and choose
> User Preferences > Audio Preferences >
Wideband Headset.
If Wideband Headset UI Control is disabled,
from Cisco Unified Communications Manager
Administration, choose Device > Phone >
Phone Configuration to set this value.
If you allowed this option to be user controllable
(in the Wideband Headset UI Control option),
the user-configured value takes precedence.
From Cisco Unified Communications Manager
Administration, choose System > Enterprise
Parameters.
From Cisco Unified Communications Manager
Administration, choose Device > Phone.
OL-15790-01