Network Statistics - Cisco 7975G Software Manual

Network Statistics

Table 8-2
Item
Auto Line Select
DSCP for Call Control
DSCP for Configuration
DSCP for Services
Security Mode
Web Access Enabled
Span to PC Port
PC VLAN
Forwarding Delay
CDP: PC Port
CDP: SW Port
LLDP-MED: SW Port
LLDP: PC Port
LLDP Power Priority
LLDP Asset ID
Network Statistics
These network statistics areas on a phone's web page provide information about network traffic on the
phone:
•
•
•
Cisco Unified IP Phone 7975G Administration Guide for Cisco Unified Communications Manager 7.0 (SCCP and SIP)
8-8
Network Configuration Area Items (continued)
Ethernet Information area—Displays information about Ethernet traffic.
items in this area.
Access area—Displays information about network traffic to and from the PC port on the phone.
Table 8-4 describes the items in this area.
Network area—Displays information about network traffic to and from the network port on the
phone. Table 8-4 describes the items in this area.
Chapter 8
Description
Indicates whether the phone shifts the call focus to incoming calls on
all lines.
DSCP IP classification for call control signaling.
DSCP IP classification for any phone configuration transfer.
DSCP IP classification for phone-based services.
Displays the security mode that is set for the phone.
Indicates whether web access is enabled (Yes) or disabled (No) for the
phone.
Indicates whether the phone will forward packets transmitted and
received on the network port to the access port.
VLAN used to identify and remove 802.1P/Q tags from packets sent to
the PC.
Indicates whether the internal switch begins forwarding packets
between the PC port and switched port on the phone when the phone
becomes active.
Indicates whether CDP is supported on the PC port.
Indicates whether CDP is supported on the switch xport.
Indicates whether Link Layer Discovery Protocol Media Endpoint
Discovery (LLDP-MED) is enabled on the switch port.
Indicates whether Link Layer Discovery Protocol (LLDP) is enabled
on the PC port.
Advertises the phone's power priority to the switch, enabling the
switch to appropriately provide power to the phones. Settings include:
• Unknown—default
• Low
High
•
Critical
•
Identifies the asset ID assigned to the phone for inventory
management.
Monitoring the Cisco Unified IP Phone Remotely
Table 8-3 describes the
OL-15790-01