Table of Contents
Advertisement
7
6
5
10
9
8 4
CAUTION! TO REDUCE THE RISK OF ELECTRIC SHOCK, GROUNDING
OF THE CENTRE PIN OF THIS PLUG MUST BE MAINTAINED
ATTENTION! POUR RÉDUIRE LE RISQUE DE CHOC ÉLECTRIQUE
LA FICHE CENTRALE DE LA PRISE DOIT ÊTRE
BRANCHÉE POUR MAINTENIR LA MISE À LA TERRE
ETHERNET
UPDATE
HOST
100-120~
T8AH 250V
220-240~
T4AH 250V
RS 232
CAN BUS
IR
IN
OUT
TRIGGER
AUTO-STANDBY
Rear Panel
The following descriptions are intended as a quick reference, should you have
any questions about your new product. Please see the next section (entitled
Installation) for specific advice on incorporating your new amplifier into your
system.
1
11
12
INPUT
OUTPUT
CLASS 2 WIRING
Balanced (XLR) Input
Balanced audio interconnections were originally developed for the
telephone and more recently have been used in the professional audio
world for preserving the delicate nuances of extremely small microphone-
level signals. For many years now, they have also been used by
performance-oriented companies such as Classé to preserve every nuance
of the finest audio recordings in your collection.
Technically, balanced audio interconnections provide two distinct benefits:
they double the signal's strength as it travels from one component to the
next, increasing the potential Signal-to-Noise ratio by 6 dB; they also do
an excellent job of rejecting noise and interference that might otherwise be
picked up between the components. If executed as in the Delta STEREO
with a high degree of symmetry between the inverting and non-inverting
signal paths, balanced connections can offer the best performance.
For this reason, we strongly recommend using the balanced analog
interconnections between your Classé components wherever possible.
The pin assignments of these XLR input connectors are:
Pin 1: Signal ground
Pin 2: Signal + (non-inverting)
Pin 3: Signal – (inverting)
Connector ground lug: chassis ground
These pin assignments are consistent with the standard adopted by the
Audio Engineering Society (AES14-1992).
3
13
RIGHT
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
2
1
LEFT
INPUT
OUTPUT
CLASS 2 WIRING
9
Advertisement
Table of Contents
