Removing And Replacing The Base Chassis - Fujitsu P3AM-5382-03ENZ0 Installing, Starting Up And Maintaining

Eternus lt20 s2 lto library
Table of Contents

Advertisement

Chapter 5 Servicing

5.4 Removing and Replacing the Base Chassis

5.4
Removing and Replacing the Base Chassis
You will need a screwdriver for TX20 screws to remove and replace the base chassis assembly. Before
beginning, be sure the tape drive does not contain a tape cartridge. To remove a cartridge from the drive, see
"3.4.7.1 Moving Media within the Library" (page
To remove the base chassis from the rack and replace it:
Procedure
1
Obtain adequate assistance to lift and stabilize the library during removal and replacement.
2
Unlock the magazines and remove them from the library to take out the cartridges. Set the
magazines in again.
3
Turn off power to the library, disconnect all cables and the terminator, if present.
4
From the front of the library loosen the two screws anchoring the mounting brackets on the
library to the rack.
5
Remove your library from the rack.
6
Remove the replacement library enclosure from the packing materials.
7
Place the replacement library enclosure on a solid surface in preparation for installation into
the rack.
8
Loosen the thumbscrews on the tape drive, and pull the tape drive handle while supporting
the bottom of the drive to remove it from your library.
9
Install your drive in the replacement library enclosure.
10
Remove the shipping lock on the rear panel.
11
Store the lock and label to the top cover of the replaced library (see
12
Slide the replacement library enclosure onto the metal rails that are already in position in
the rack.
13
Tighten the mounting bracket screws to anchor the replacement library enclosure to the
rack.
14
Plug in the power cord and host interface cable (and the terminator, if required) into the
replacement library enclosure.
15
Power on the library.
16
Run the library Verify test (see
FUJITSU Storage ETERNUS LT20 S2 LTO Library Installing, Starting Up and Maintaining
62).
"3.4.8.1 Performing General Library Diagnostics" (page
83
Copyright 2014 FUJITSU LIMITED
Figure
6.1).
64)).
P3AM-5382-03ENZ0

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Eternus lt20 s2 lto library

Table of Contents