Chapter 2 Installing the Tape Library
2.4 Remove the Shipping Lock
2.4
Remove the Shipping Lock
The shipping lock, which prevents the robot transport mechanism from moving during shipment, must be
removed before the library is powered on.
A yellow label with instructions regarding the shipping lock covers the power button, as shown in the
following picture:
Figure 7: Instructions for shipping lock
The shipping lock is held in place with a label and is located in the top center of the library. After the shipping
lock is removed, it should be stored on the rear panel right side (next to power connector) of the library for
future use.
To remove and store the shipping lock:
Procedure
1
Remove the yellow label that is securing the lock to the top of the library, and then remove
the lock (see
Figure 2.2 Removing shipping lock and label
Figure 7: Removing shipping lock and label
FUJITSU Storage ETERNUS LT20 S2 LTO Library Installing, Starting Up and Maintaining
Figure
2.2).
21
Copyright 2014 FUJITSU LIMITED
P3AM-5382-03ENZ0