Removing And Replacing The Base Chassis - Fujitsu ETERNUS LT20 S2 Installing, Starting Up And Maintaining

Removing and Replacing the Base Chassis

6.4 Removing and Replacing the Base Chassis
You will need a screwdriver for TX20 screws to remove and replace the base
chassis assembly. Before beginning, be sure the tape drive does not contain a
tape cartridge. To remove a cartridge from the drive, see
within the Library" on page
To remove the base chassis from the rack and replace it:
1. Obtain adequate assistance to lift and stabilize the library during removal
and replacement.
2. Unlock the magazines and remove them from the library to take out the
cartridges. Set the magazines in again.
3. Turn off power to the library, disconnect all cables and the terminator, if
present.
4. From the front of the library loosen the two screws anchoring the mounting
brackets on the library to the rack.
5. Remove your library from the rack.
6. Remove the replacement library enclosure from the packing materials.
7. Place the replacement library enclosure on a solid surface in preparation for
installation into the rack.
8. Loosen the thumbscrews on the tape drive, and pull the tape drive handle
while supporting the bottom of the drive to remove it from your library.
9. Install your drive in the replacement library enclosure.
10. Remove the shipping lock on the rear panel.
11. Store the lock and label to the top cover of the replaced library (see figure
76).
12. Slide the replacement library enclosure onto the metal rails that are already
in position in the rack.
13. Tighten the mounting bracket screws to anchor the replacement library
enclosure to the rack.
14. Plug in the power cord and host interface cable (and the terminator, if
required) into the replacement library enclosure.
15. Power on the library.
102
71.
Servicing
section "Moving Media
ETERNUS LT20 S2