Magazines; Inserting Tape Cartridges Into A Magazine; Figure 3.5 Insert Magazines - Fujitsu P3AM-5382-03ENZ0 Installing, Starting Up And Maintaining

Chapter 3 Operating the LTO Library

3.3 Magazines

3.3 Magazines
Cartridges are stored in magazines. Up to 4 cartridges can be stored in each magazine. Magazines may be
removed and inserted individually.
The ETERNUS LT20 S2 LTO library has two magazines in the 1U library (see
Magazine access can be password protected. For safety reasons, the robot motion is stopped when a
magazine is removed.
The magazines can be released using the Operator Control Panel (OCP) or the Remote Management Unit
(RMU).
In case the OCP or RMU initiated process has failed or the library no longer has power, a manual emergency
release is available. See
3.3.1

Inserting Tape Cartridges into a Magazine

Procedure
1
Unlock the magazines and remove them from the library:
• Use the OCP, see
Use the RMU, see
•
2
Insert cartridges in the magazines
3
Put the full magazines back to the tape library (see

Figure 3.5 Insert magazines

FUJITSU Storage ETERNUS LT20 S2 LTO Library Installing, Starting Up and Maintaining
See"3.4.6.5 Changing the Administrative Password" (page
"4.4 Magazine Does not Unlock via OCP or RMU" (page
"3.3.2 Removing and Replacing a Magazine Using the OCP" (page
"3.3.3 Removing and Replacing a Magazine Using the RMU" (page 42)
40
Copyright 2014 FUJITSU LIMITED
Figure 3.5
58).
73).
Figure 3.5)
End of procedure
and Figure 3.10).
41), or
P3AM-5382-03ENZ0