Input Modes; Power On/Off - Fujitsu P3AM-5382-03ENZ0 Installing, Starting Up And Maintaining

Chapter 3 Operating the LTO Library
3.1 Operator Control Panel (OCP)
3.1.5

Input Modes

There are several modes to enter values in the different menu items. These values are selectable predefined
values, toggle values (e.g. On/Off) and numerical values like network addresses.
3.1.5.1 Selectable Predefined Values
After navigating to the menu item the various predefined values can be selected with the (▲) and (▼) key. As
soon as the display shows the correct value it will be entered by pressing the ENTER key.
3.1.5.2 Toggle Values
Toggle values are used to switch between two different states like On and Off. After navigating to the menu
item the display shows the actual state. Pressing the ENTER button will switch to the possible new state.
Pressing ENTER a second time will take over this new state. This procedure works vice-versa.
3.1.5.3 Numerical Values
Numerical values are needed for network addresses, PIN entries and other configuration entries. After
navigating to the menu item which should be changed the actual value will be displayed and the cursor stays
on the first digit. The value can be incremented/decremented with the (▲) and (▼) button. After pressing the
ENTER button the cursor is set to the next editable digit. It can be changed in the same way. After pressing the
ENTER button at the last digit the complete entry will be stored. Pressing the CANCEL button will cancel the
whole edit process and the old value is valid again.
3.1.6

Power ON/OFF

Part of the Operator Control Panel is the Power On/Off button. Pressing this button will initiate a controlled
Power Down of the unit (soft landing). The following operations will take place before the unit shuts down
completely:
• The display indicates with an appropriate message that the shutdown is in progress.
• The library controller finishes all ongoing library and drive activities.
• The robot is moved to its home position.
• The library controller switches off the power supply's secondary side.
To abort the shutdown process the user has to press Cancel within the first 3 seconds.
•
FUJITSU Storage ETERNUS LT20 S2 LTO Library Installing, Starting Up and Maintaining
34
Copyright 2014 FUJITSU LIMITED P3AM-5382-03ENZ0