Chapter 2 Installing the Tape Library
2.5 Rack Mounting the Tape Library
2
Replace the label on top of the library and store the shipping lock next to power supply (see
Figure
Figure 2.3 Storing shipping lock and label
If you need to transport the library, it is recommended that the shipping lock and label is replaced on
the top cover (see
2.5
Rack Mounting the Tape Library
WARNING
2.5.1
Preparing
Before installing the library:
Make sure that the host bus adapter card installed in the host computer, any necessary device drivers, and
•
your backup software are compatible with the library. Make certain that an any necessary drivers installed
in the host computer are compatible with the tape drive in a library.
You can install the software on the host computer before or after library installation. However, if you install
•
the software first, you may need to reconfigure it for use with the library after library installation is
complete.
•
The library must be operated in the horizontal position. Do not place the library on its side, and do not
place objects on top of the library.
CAUTION
FUJITSU Storage ETERNUS LT20 S2 LTO Library Installing, Starting Up and Maintaining
2.3).
"Chapter 6 Packaging before Transportation" (page
Weight!
Risk of personal injury or damage to the loader.
Always remove all tapes to reduce the overall weight of the loader.
•
Observe local health and safety requirements and guidelines for manual
•
material handling.
Before performing any installation or maintenance procedures, be sure that the
library power switch is in the off position and that the power cord is disconnected
from the library and the outlet.
Copyright 2014 FUJITSU LIMITED
22
85)).
End of procedure
P3AM-5382-03ENZ0