Connecting The Power Connector - Advantech PWS-1419 User Manual

3-6 Connecting the power Connector

The plug from the power supply will only insert in one orientation. Push down firmly making
sure the hook on the terminal block clips onto the plug.
Connecting the Chassis Cables
The chassis has 3 internal cooling fan to reduce the temperature of the system, connecting the
fan power connector to fan adapter board.
The flat panel display receives its power from
the power supply. Find the wire bundle that ends
in a 4-pin power connector from the chassis side
and plug it into one of the power supply
connectors.
3-7 Installing driver disk to the drive Cage
Step 1. Take back the driver cage, take the screw#5 and washer #3 from your pack age, and
secure the hard disk to driver cage
Step 2. Take the floppy disk and Screw #2 from your package, and secure the floppy disk to
the drive cage.
Step 3. Connect trhe cables to hard disk and floppy disk.
Interior space is going to be tightened. While you have the drivers outside of
the chassis, plug in the signal cables.
Ribbon cables should always be connected with the c olored stripe to Pin 1 on the
connectors.
PWS-1409/1419 User's Manual
34