Installing The Hard Drive; Installing The Slim Floppy Disk Drive - Advantech PWS-1419 User Manual

2-11 Installing the hard driver
The drive cage supports one slim Floppy disk and a 3.5" Hard disk drives.
Step 1. Take back the driver cage and take off the screw#5 and washer #3 from your
package.
Step 2. Insert the hard drives to drive cage.
Step 3. Align the mounting holes and insert the screws# 5 (please insert the washer #3 for
shock-mount protect. Tighten the screws.
Insert the screw #5 to secure hard drive
to driver cage (insert the metal washer
#3 between the cage and screw, it's a
shock mount design for the hard driver
There are a small copper pipe inside the
rubber , make sure it is still in the rubber.
FCB shows the mounting pointsfor
floppy interface board
2-12 Installing the slim floppy disk driver
Step 1. Take off the floppy driv e interface board, floppy interface board, Screw #8, #2 from
the package.
Step 2. Align the mounting holes and insert the screws# 8 to fix the slim floppy disk
Use screws #8 to secure the floppy
PWS-1409/1419 User's Manual
23
The other side will be same as above
The other side