Preparing To Start The System; Connecting The Video And Input Devices - Advantech PWS-1419 User Manual

Slant the add-on card stabilizer and put it
in the case, then set straight and fix it.
Use screw #7 to secure it.
Step 3. Slide each clip so they come in contact with the top edge of the add-on cards.
While holding the clip firmly against the card edge, tighten the bracket screws.
Step 4. Cut off any excessive part of the plas tic clip.
Step 5. Repeat these steps for the other stabilizer.
Press the plastic extender firmly against the
card edge and tighten screw.

3-12 Preparing to Start the System

3-12-1 Connecting the Video and Input Devices

The location of your video output, keyboard and pointing device connectors are board
dependent. Connect the video cable to the VGA output connector on your SBC or other graph-
ics card. Connect the keyboard and pointing device connectors to their sockets and firmly push
them into the sockets.
PWS-1409/1419 User's Manual
39
Use the screw removed earlier. Insert it into
the threaded hole and tighten it.
Cut off any excessive part of the plastic clip.