Removing The Card Stabilizers; Identifying The Internal Parts; Removing The Back Cover; Removing The Drive Cage - Advantech PWS-1419 User Manual

Chapter 3 PWS-1409 Construction
3-1 Open the chassis

3-1-1 Removing the Back Cover

Face the back of the c hassis. Remove all screws as shown. There are 7 screws along the
perimeter of the back cover that holds the back cover to the chassis.
Always power down the system.
Always turn off any peripheral devices connected to
the system.
Always unplug the AC power cord from the chassis.
Face the back of the chassis. Remove all
the release screws as shown. There are 7
screws along the perimeter of the back cover
that secures it to the chassis.

3-2 Removing the Card Stabilizers

The stabilizer is designed to securely hold down add-on
cards in their expansion slots with plastic hold-down clips.
The stabilizer must be removed prior to adding boards and
components in the chassis.
Step 1. Remove the card stabilizer release screws as shown.
Step 2. Remove the stabilizer and set them aside.

3-3 Identifying the Internal Parts

After you remove the card stabilizer you
can check the case contains, the figure is on
the next page. The CDROM cable and audio
cable will come with the slim CDROM
option.

3-4 Removing the Drive cage

Remove the 2 screws and take out the cage.
After you removed the drivers cage from the chassis, set it aside. Your are now ready either to
install the drives in the drive cage or install the backplane.
PWS-1409/1419 User's Manual
31