Installing The Sbc; Setting Your Sbc Jumpers - Advantech PWS-1419 User Manual

2-14 Installing the SBC

2-14-1 Setting your SBC Jumpers

Before installing the motherboard in the chassis, install the CPU and set any dip-s witch or
jumper on the SBC. Since jumper and dip-switch settings are board-specific, consult the
manual that comes with the SBC and carefully follow the directions to configure your SBC.
Make sure that at no time you are working on any electrical or electronic components while any
part of the system is energized. Always disc onnect the power! Use caution to protect the
delic ate elec tronic components. Ground your self during the installation of the motherboard
and other c omponents.
Installing the Standoffs
Step1. Locate the slot on the backplane you wish to use. Remove the slot cover screw
and then remove
Step 2. Set the card jumpers or switches according to the manufacturer's requirements if
necessary.
Step 3. Connect of the small cables from the chassis . The cables are color coded and labeled.
Consult your SBC manual to connect these cables to the correct set of terminal pins.
It may be difficult to know for sure that the polarity of the LED connections is correct. If an LED
fails to light when it should during the test phase, you will be able to shut down and reverse
connections as needed.
STEP 4. Connect the driver signal cable to SBC
Connect the CD ROM, floppy drive, hard disk driver signal cable to the SBC before the SBC
fix. The ribbon cables should always be connected with the colored stripe to Pin #1 on the
connectors.
Step 5. Hold the card and align the edge connectors with the slot. Firmly push the card into the
slot.
Step 6. Use the screw removed earlier. Insert it into the threaded hole and tighten it.
PWS-1409/1419 User's Manual
1.
2.
3.
4.
5.
26
Power-on indicator LED (orange and black).
Hard disk LED (blue and black)
System reset switch (white and black).
Power switch (yellow and white).
Internal PC speaker (blue and white).