2.2
Installation Procedures
2.2.1
Connecting Power Cord
The panel PC supports 9 - 32 V
when connecting the power cord. Please follow the below procedures to connect the
power cord:
1.
Plug the 2-pin connector into the DC inlet of the panel PC.
2.
Connect power cord with power adapter with the 3-pin female connector.
2.2.2
Connecting Keyboard and Mouse
Connect mouse and keyboard to the I/O connector of the panel PC. Refer to Figure
2.3, C, USB.
2.2.3
Switching on the Panel PC
Power switch is located at the lower right corner of the rear cover. Refer to Figure 2.3,
J, Power switch.
Note!
Power cord and adapter are optional.
PPC-415 TGL User Manual
power supply. Please always hold the plug end
DC
Figure 2.4: Connecting Power Cord
10