Table of Contents
Advertisement
98 | Performance Series HREP2 DVR User Guide
2.
3.
4.
Motion Sensor Settings
In this menu you can set an action to execute when a motion is detected. For the motion sensor
detection settings, see
1.
2.
www.honeywell.com/security
Use the
,
,
, and
sensor input method and operation.
•
NAME: You can specify the name of the alarm sensor.
•
OPERATION: You can specify the type of the alarm sensor.
•
N/O (Normal Open): Normally the sensor is left Open. If the sensor switches to
Close, an event will be triggered.
•
N/C (Normal Close): Normally the sensor is left Close. If the sensor switches to
Open, an event will be triggered.
•
LINKED CAMERA: Set the camera to sync with the alarm sensor if it is triggered.
If you have set the alarm recording and the sensor detects the recording, all
synchronized cameras will start alarm recording.
•
ALARM OUTPUT: Specify the alarm output channel if it is detected by the alarm
sensor. The alarm will be output to the specified channel.
•
: Specify the output of the buzzer if an alarm is detected by the alarm sensor.
•
: Select to display the video popup if an alarm is detected by the alarm sensor.
If there exist multiple LINKED CAMERA, the video popup will be displayed in the
maximum split screen mode.
•
: Select to display the OSD popup message if it is detected by the alarm
sensor.
•
: Select to send an email if detected by the alarm sensor.
To apply the change, click APPLY at the bottom of the screen.
When finished, press the EXIT button on the remote control or click CLOSE in the lower
part of the screen. The confirmation message appears and you will return to the previous
menu.
Motion Sensor on page
From SYSTEM SETUP
Use the
,
,
, and
ignorance interval and operation.
•
IGNORING INTERVAL: Specify the minimum interval of the motion event occurrence.
For example, even if you have set the minimum frequency to 5 seconds and another
motion event occurs in less than 5 seconds after the last motion event occurred, the
new event will be ignored. If too many motion events occur, adjust to shorten the
interval.
Note
Motion recording will be triggered immediately after the motion occurred
regardless of the above settings.
•
ALARM OUTPUT: Specify the alarm output channel if a motion is detected by the
motion sensor.
•
: Specify the output of the buzzer if a motion is detected by the motion sensor.
•
: Select to display the video popup if a motion is detected by the motion
sensor.
•
: Select to send an email if a motion is detected by the motion sensor.
buttons on the remote control or use the mouse to specify the
59.
EVENT, select MOTION SENSOR (see
buttons on the remote control or use the mouse to specify the
Figure
4-52).
Advertisement
Table of Contents
