92 | Performance Series HREP2 DVR User Guide
3.
4.
Event Setup
Define various events, and specify the conditions to notify the user in various ways.
Alarm Out
Specify the alarm output conditions with the work schedule.
Alarm Out
1.
2.
www.honeywell.com/security
Click DETAIL INFO to view the details.
•
NORMAL: The disk is in a normal state.
•
CHECK: The disk has an error so that you need to check the disk or the
connection cables of the disk.
If you leave the problem unresolved, no recording may be enabled. So it is
recommended that you replace the disk immediately.
•
ERROR: The disk fails or is unable to use due to an error of the disk or the cable.
The disk should be replaced immediately.
Contact the retailer or the customer service to replace the disk.
•
S.M.A.R.T CHECK INTERVAL: Specify the S.M.A.R.T check interval.
Click CHECK NOW to start checking.
To apply the change, click APPLY at the bottom of the screen.
When finished, press the EXIT button on the remote control or click CLOSE in the lower
part of the screen. The confirmation message appears and you will return to the previous
menu.
From SYSTEM SETUP
Use the
, and ENTER buttons on the remote control or use the mouse to
,
,
,
select ALARM OUT and configure the related settings.
•
NAME: You can rename the alarm.
•
OPERATION: Set the alarm output mode.
•
N/O (Normal Open): It normally stays Open. However, if an event occurs, it will
switch to Close.
•
N/C (Normal Close): It normally stays Close. However, if an event occurs, it will
switch to Open.
•
DURATION: Specify the duration of the alarm output.
•
TRANSPARENT: Keep the alarm out for as much time as the event lasts.
•
UNTIL KEY: Keep the alarm out until a mouse or remote control button is
pressed.
•
5 ~ 300 SEC: Keep the alarm out for as long as specified.
•
TEST: Forcibly output the alarm for the test purpose.
EVENT, select ALARM OUT (see
Figure
4-45).