Table of Contents
Advertisement
78 | Performance Series HREP2 DVR User Guide
3.
4.
5.
DDNS Settings
You can configure the DDNS settings so that remote users who are connected to the network
can access remotely.
www.honeywell.com/security
Figure 4-27
IP Setup Screen
Deselect the DHCP option to enable manual static IP address configuration.
•
IP ADDRESS: Provide the IP address.
•
GATEWAY: Provide the gateway address.
•
SUBNET MASK: Provide the subnet mask address.
•
1ST DNS SERVER: Enter the address of the primary DNS server.
•
2ST DNS SERVER: Enter the address of the secondary DNS server.
•
RTSP SERVICE PORT: Port number that the remote client receives the DVR video
from.
•
WEB SERVICE PORT: Port number used for connecting to the DVR with the web
browser.
•
PORT FORWARDING: If you are using a router, you can set the port forwarding so
that external access to the DVR is enabled.
If the router does not support the uPnP protocol, you must set the port forwarding
manually. For more information, contact your network administrator.
•
DELETE PORT: Release the port forwarding settings for the router.
•
MAX TX SPEED: Limit the network transfer rate to access a remote client.
The video signal may be transferred at a less rate than specified, which depends on
the status of your network connection.
To apply the change, click APPLY at the bottom of the screen.
When finished, press the EXIT button on the remote control or click CLOSE in the lower
part of the screen. The confirmation message appears and you will return to the previous
menu.
Advertisement
Table of Contents
