Table of Contents
Advertisement
Chapter 2. NAMES AND FUNCTIONS OF PARTS
Classification
Program setting
Erases or resets a set value.
(When a set value flickers.)
Cancels change in set value.
(When a set value flickers.)
Inserts or delete a segment when a pattern SP setting is started.
Changes RAMP-X
pattern SP setting is completed.
Starts a program number change.
Ends program setting.
Starts program copy. (In basic display status)
Program copy
Changes program number at copy destination.
Executes the copy.
(When a set value flickers.)
Ends program copy.
Memory card
Starts a data write operation to the memory card.
operation
(In basic display status)
Writes data to the memory card.
Starts a data read operation from the memory card.
(In basic display status)
Reads data from the memory card.
Changes selected memory card operation.
Enters memory card operation.
Interrupts memory card operation.
Returns a check status of the general reset. (In basic display status)
General reset
Executes a general reset.
Interrupts a general reset.
Key chord functions
PROG + RUN/HOLD
PROG + DISP
FUNC + →
2-6
Function
«
RAMP-T or RAMP-X
: Reset key
Press the RUN/HOLD key while holding down the PROG key in basic status
display to perform a RESET.
The READY mode is invoked when a reset is performed in the RUN, HOLD,
FAST, END, or READY FAST modes. This RESET operation does not work
in the READY mode.
: Advance key
Press the DISP key while holding down the PROG key in the program run mode
in basic status display to perform an ADV (advance) operation. The next segment
is displayed when this action is performed in the RUN, HOLD, FAST, or
READY FAST modes. This ADV operation does not work in the READY mode.
: Fast key
Press the → key while holding down the FUNC key in the program run mode
in basic status display to perform a FAST operation.
The system changes from the RUN or HOLD mode to the FAST mode. If the
system is in the READY mode, it goes to the READY FAST mode.
«
RAMP-E when a
Key operation
FUNC + CLR
DISP
FUNC + ENTER
FUNC + PROG
DISP
+ PROG
¯
ENTER
DISP
SAVE
LOAD
¯
ENTER
DISP
FUNC + CLR + MESSAGE
ENTER
DISP
Advertisement
Table of Contents
