Setting Cycle Items - Honeywell DCP552 Mark II User Manual

Setting cycle items

Display
NOTE
(1) In the set value display state, move to the cycle item to be set for the segment
on the programming map.
(A cycle item is a program setting and is the same for each segment.)
(2) Press the ENTER key to make display panel 2 flash (registration of first
setting).
(3) Use the ↑, ↓, ←, and → keys to make the first setting – setting the cycle
value.
Setting range: 0 to 10000
(4) Press the ENTER key to stop the flashing on display panel 2.
(Pressing the FUNC and CLR keys causes display panel 2 to return to unset
state "0 " and the flashing stops.)
Set cycle count value
P R O G R A M C Y C L E
• A cycle item is a program setting and is the same for each segment.
• When setup data C60 is set to 1, a cycle item on the programming map is
skipped and not displayed.
A cycle item setting does not use subfunctions.
Chapter 8. PROGRAM SETUP
PROG SEG
Program
Segment
number
number
PROFILE
Pattern trend
8-17