Honeywell DCP552 Mark II User Manual page 115

Chapter 7. PARAMETER SETUP
*1: The meaning of auxiliary setting 1 for special segment is shown below.
–2: Two segments before the final segment
–1: One segment before the final segment
0: Final segment
*2:
When auxiliary setting 1 of RAMP-E time monitoring is set to 0.0 sec, event output is off.
*3: Auxiliary setting 1 and auxiliary setting 2 of segment time and program time that determine display
unit and range of segment are set by setup data C62 settings as follows.
When C62 is set to 0: 0 hours 00 min to 500 hours 00 min
When C62 is set to 1: 0 min 00 sec to 500 min 00 sec
When C62 is set to 2: 0.0 sec to 3000.0 sec
Event type
Meaning READY, READY FAST,
Message READY, READY FAST
Range of auxiliary Conditions assessed for each channel
setting 1 0: only assigned channel
Message 1: OR condition for both channels
2: AND conditions for both channels
Range of auxiliary Unused
setting 2
Message
Setting category Instrument type
Operation category Mode type
7-16
130 131
END
END
Conditions assessed for each channel
0: only assigned channel
1: OR condition for both channels
2: AND conditions for both channels
Unused
Instrument type
Mode type
1: First segment
2: Second segment
132
G.SOAK wait
G.SOAK
Conditions assessed for each channel
0: only assigned channel
1: OR condition for both channels
2: AND conditions for both channels
Unused
Instrument type
Mode type
133
MANUAL
MANUAL
Conditions assessed for each channel
0: only assigned channel
1: OR condition for both channels
2: AND conditions for both channels
Unused
Instrument type
Mode type