Table of Contents
Advertisement
Voltage, Open collector output (with setup data C22 set between 2 to 5)
Initialization of PID
Setting: variable parameter PA27, PA96
control computation
Setting: PID paramete P / l / d / rE (for CH2)
PID control computation
Setting: variable parameter PA24
Output deviation limiter
Setting: PID parameter oL / oH (for CH2)
Upper and lower output limiter
During ON-OFF control
During AT executing
During overrange
In READY mode
In MANUAL mode
Manipulated variable (MV2)
Setting: variable parameter PA25
Proportional output cycle
during output 2
Output voltage 2
(For 6D output)
adjustment
Setting: setup data C96
Voltage time proportional output
Output 2
Proportional output when open collector is on
Setup data C24
Setting: variable parameter PA26
ON-OFF control computation
Setting: variable parameter PA93, PA94, PA95
AT computation
Setting: setup data C39, C40
Manipulated variable during overrange
Setting: setup data C38
Manipulated variable in READY mode
Setting: setup data C41, C42
Preset MANUAL value
MANUAL Manipulated variable
Setup data C94
(not valid during ON-OFF control and AT execution or
when setup data C22 is set to 2 or 4.)
Chapter 5. FUNCTIONS
(PID parameter oL, oH are valid when setup
data C22 is set to 3 or 5.)
(Variable parametesr PA94 and PA95 are valid
when setup data C22 is set to 3 or 5, respectively.)
(AT not performed during CH2 O
sensor input)
2
5-35
Advertisement
Table of Contents
