Honeywell DCP552 Mark II User Manual page 92

Chapter 6. OPERATION
DISP key function (when variable parameter PA03 is set to 1)
Display F1
Display F2
Display F3
Display F4
6-10
The DISP key is used to cycle through the displays in the following order:
Display F1, display F2, display F3, display F4, display F1.
When CH1 and CH2 are both in the fixed command control mode, the display
show the information shown in the figures below. When only one channel is in the
fixed command control mode, the displays provide the same information is shown
in the program run mode. Note, however, that channel time and remaining cycle
count are displayed as [-----].
PV
PV 1
PV 2
Deviation 1
DEV
Deviation 2
Output value 1 (%)
OUT
Output value 2 (%)
When used in MANUAL mode, the number of digits available for output values
flashes.
SP 1
SP
SP 2
PROG SEG
PROFILE
PROG SEG
PROFILE
PROG SEG
PROFILE
PROG SEG
PROFILE