Table of Contents
Advertisement
Voltage, Open collector output (with setup data C21 set between 2 to 5)
Initialization of PID
Setting: variable parameter PA17, PA43
control computation
Setting: PID paramete P / l / d / rE (for CH1)
PID control computation
Setting: variable parameter PA14
Output deviation limiter
Setting: PID parameter oL / oH (for CH1)
Upper and lower output limiter
During ON-OFF control
During AT executing
During overrange
In READY mode
In MANUAL mode
Manipulated variable (MV1)
Setting: variable parameter PA15
Output 1 time proportional
output cycle
Output voltage 1 control (During 6D output)
Setting: setup data C95
Voltage time proportional output
Output 1
Proportional output when open collector is on
Setup data C23
Setting: variable parameter PA16
ON-OFF control computation
Setting: variable parameter PA08, PA09, PA10
AT computation
Setting: setup data C33, C34
Manipulated variable during overrange
Setting: setup data C32
Manipulated variable in READY mode
Setting: setup data C35, C36
Preset MANUAL value
MANUAL Manipulated variable
Setup data C93
(ON-OFF control and AT execution are valid
when setup data C21 is set to 2 or 4, respectively.)
Chapter 5. FUNCTIONS
(PID parameter oL, oH are valid when setup
data C21 is set to 3 or 5.)
(Variable parameter PA09 and PA10 are valid
when setup data C21 is set to 3 or 5,
respectively.)
5-33
Advertisement
Table of Contents
