Table of Contents
Advertisement
Chapter 8. PROGRAM SETUP
Starting programming
Key operations
Start of display items
State transition
FUNC+PROG key
Program setting status
FUNC+DISP key
ENTER key
(4)
DISP key
1st setting
registered
status
,
¯ key
,
¬
® key
Check status of
program or delete
CLEAr
8-2
Start programming by pressing the FUNC and PROG keys in the normal display
mode.
In the program setting state, PRG LED on the console lights and the decimal
points in the program number display and the segment number display lights.
Note, however, that the program setting state cannot be entered in the following
cases.
• In the fixed command control mode (and the fixed command control data
ConSt is set to 1)
• When keylock is engaged (and variable parameters PA01 is set to 2 or 3)
In the following condition changes cannot be made in the program setting state.
• When a program is protected (and variable parameter PA02 is set to 1, 3 or 5)
When programming is started, the number of the started program and its segment
are displayed.
The figure below shows the transition of states during programming.
The numbered items (1) to (20) are described on the following page.
(1)
(19)
DISP key
(20)
,
(2)
¯ key
ENTER key
FUNC+CLR key
(12)
ENTER key
(6)
FUNC+CLR key
FUNC+ENTER key
(Pattern item)
(5)
(8)
FUNC+CLR key
(Pattern item)
ENTER key
(9)
DISP key
Normal display mode
,
(3)
FUNC+PROG key
¬
® key
(16)
Set point display status
(11)
(12)
DISP key
2nd setting
registered
status
(7)
,
¯ key
,
(10)
¬
® key
DISP key
,
¯ key
,
(17)
¬
® key
ENTER key
(18)
Program number or
segment number flashes
FUNC+ENTER
(13)
key
(Pattern item)
ENTER key
DISP key
Check before inserting
or deleting segments
. flashes
InS
. flashes
dEL
,
(14)
¯ key
(19)
(15)
Advertisement
Table of Contents
