Setpoint Ramp/Soak Programming - Honeywell UDC2800 Product Manual

Chapter 5 - Monitoring and Operating the Controller
Configure the mode at "Control" Set Up Group, function prompt
"Power Up Mode". See Control Set Up Group for more information.

Setpoint Ramp/Soak Programming

Introduction
The term "programming" is used here to identify the process for
selecting and entering the individual ramp and soak segment data
needed to generate the required setpoint versus time profile (also
called a program). There are 8 programs, and each program has 8
segments including 4 ramp segments and 4 soak segments.
A segment is a ramp or soak function which together make up a
setpoint program. Setpoint Ramp/Soak Programming lets you
configure 4 ramp and 4 soak segments to be stored for use as one
program or several small programs. You designate the beginning
and end segments to determine where the program is to start and
stop.
Review program data and configuration
While the procedure for programming is straightforward, and aided
by prompts, we suggest you read the table Program Contents below
lists the program contents and an explanation of each to aid you in
configuration. Then refer to SP Ramp/Program Set Up Group to do
the setpoint program. See SP Ramp/Program Set Up Group for more
information.
Make sure is disabled.
SP Ramp Function
Fill out the worksheet
Refer to the example below (Ramp/Soak Profile Example) and draw a
Ramp/Soak Profile on the worksheet provided below (Program record
sheet) and fill in the information for each segment. This will give you
a record of how the program was developed.
Operation
See Run/Monitor the program for more information.
216