Online Displays; Introduction; Individual Cell Display; Figure 1-2 Representative Process Value Display For A Cell In Standard Range Analyzer - Honeywell 9782 Series Operator's Manual

Conductivity/Resistivity Analyzer/Controller

1.3.2 Online Displays

Introduction

The online displays available when the operator presses the DISPLAY key depend on the
number of cells connected to the Analyzer/Controller, and on the special features used. The
instrument's tagname (or other configurable text) is at the top of the screen for all displays
except the digital clock and the AutoClean Sequence display. Every display includes an "alarm
stripe", a line dedicated to displaying process alarm messages, status messages, and system
diagnostic messages, whenever any are active.

Individual cell display

For each cell connected to the Analyzer/Controller an online display similar to Figure 1-2 is
provided. The information on this display includes:
the value measured by the cell, with the appropriate unit of measure filled in
an indication of whether the value is temperature compensated (TC) or not
compensated (NC); the display can be toggled between displaying compensated and
raw data using the F1 function key
the temperature in C
if the value displayed is a percent concentration (9782C-W0 only), the chemical will
be identified above the alarm stripe
In addition of the function key used to toggle the temperature compensation display, function
keys are available to access calibration displays (without going through the menus), and to
acknowledge alarm stripe messages.

Figure 1-2 Representative Process Value Display for a Cell in Standard Range Analyzer

1-8 9782 Series Conductivity/Resistivity Analyzer/Controller - Operator's Manual
CONDENSATE
8.59
25.2°C
ALARM STRIPE
NC CAL
T105
TC
C1
µS
ACK
7/99