Conductivity/Resistivity Analyzer/Controller
9.2 System Status Messages
Related to operation of Analyzer/Controller
System status messages, displayed on the alarm stripe, are related to normal operation of the
Analyzer/Controller. These messages are listed in Table 9-1.
MESSAGE
AUTO CLEAN
CAL ADJ FAILED
RETRIEVING DATA
ENTERING DATA
INPUT RANGE TOO HIGH
INPUT RANGE TOO LOW
9-2
9782 Series Conductivity/Resistivity Analyzer/Controller - Operator's Manual
Table 9-1 System Status Message
This message is displayed temporarily and indicates that
an AutoClean operation is active. All alarms and outputs
are held for the duration of the AutoClean operation.
To see how much time is remaining until the next
scheduled AutoClean operation, use the DISPLAY key to
access the special Time Remaining screen.
This message indicates that a calibration operation has
been unsuccessful.
This message is displayed during I/O setup, configuration,
and calibration while the unit retrieves data from its
memory.
This message is displayed during I/O setup, configuration,
and calibration while the unit processes data entered by
the user.
User input was either greater than or less than the
allowable range.
WHEN DISPLAYED
7/99