Menu Hierarchy; Menus For Every Task; Table 1-2 9782 Conductivity/Resistivity Analyzer/Controller Menu Hierarchy - Honeywell 9782 Series Operator's Manual

1.4 Menu Hierarchy

Menus for every task

For your convenience, menus are provided for configuration, calibration, maintenance, and I/O
setup tasks. The menu hierarchy is shown in Table 1-2. Not every menu item applies to every
system.

Table 1-2 9782 Conductivity/Resistivity Analyzer/Controller Menu Hierarchy

Menu Item
CONFIGURATION
CAT/RETRANSMISSION
ALARMS
DISCRETE CONTROL
ADVANCED FEATURES
CALIBRATION
CELL CAL FACTOR
CALIBRATION TRIM
TDS CONVERSION FACTOR C1
TDS CONVERSION FACTOR C2
7/99 9782 Series Conductivity/Resistivity Analyzer/Controller - Operator's Manual
Purpose
set up Analyzer/Controller to implement
your alarm and control strategy
configure parameters for using analog
outputs for control and retransmission of
process values
specify value to be alarmed, alarm
setpoints, deadbands, and delay
specify setpoints, range limits, etc. to use
relays for control
set the clock, set up automatic cell
cleaning, and specify the computed value
to be displayed
calibration functions
enter cell-specific cal factor
calibrate system using a reference solution
with each cell; remove trim
enter a process-specific total dissolved
solids conversion factor for each cell
Introduction
Where
Described
Section 5
5.4
5.6
5.5
5.7, 5.8, 5.9
Section 8
8.3
8.4, 8.5
8.6
Table 1-2 continued on next page
1-11