9.3 Process Alarm Messages
Alarms dependent on configuration
Alarms are configurable as described in Section 5. When an alarm is active, it is always
displayed on the alarm stripe. All available alarm messages are shown in Table 9-2.
MESSAGE
CELL 1 HIGH ALM
CELL 1 LOW ALM
CELL 2 HIGH ALM
CELL 2 LOW ALM
CELL1 OR 2 HIGH ALM
CELL 1 OR 2 LOW ALM
DIFFERENCE HIGH ALM
DIFFERENCE LOW ALM
% PASSAGE HIGH ALM
% PASSAGE LOW ALM
% REJECT HIGH ALM
% REJECT LOW ALM
PPM CO2 HIGH ALM
PPM CO2 LOW ALM
RATIO HIGH ALM
RATIO LOW ALM
TEMP 1 HIGH ALM
TEMP 1 LOW ALM
TEMP 2 HIGH ALM
TEMP 2 HIGH ALM
TEMP 1 OR 2 HIGH ALM
TEMP 1 OR 2 LOW ALM
7/99
9782 Series Conductivity/Resistivity Analyzer/Controller - Operator's Manual
Table 9-2 Process Alarm Messages
Indicates alarm state, if the Analyzer/Controller is
configured to alarm on the Cell 1 and/or Cell 2 value
exceeding (high alarm) or falling below (low alarm) the
configured alarm setpoint.
Indicates alarm state, if the Analyzer/Controller is
configured to alarm on a computed value exceeding (high
alarm) or falling below (low alarm) the configured alarm
setpoint.
Indicates alarm state, if the Analyzer/Controller is
configured to alarm on the temperature from Cell 1 and/or
Cell 2 exceeding (high alarm) or falling below (low alarm)
the configured alarm setpoint.
Diagnostics and Messages
WHEN DISPLAYED
9-3