Honeywell 9782 Series Operator's Manual page 100

Conductivity/Resistivity Analyzer/Controller
If the Cell 1 solution temperature compensation is set up without TDS, and Cell 2 with TDS,
then the calibration menu will be:
If both cells' solution temperature compensation is set up with TDS, then the calibration menu
will be:
Therefore, the screens on your unit may not match exactly the calibration menus used in the
procedure tables in this section.
8-2 9782 Series Conductivity/Resistivity Analyzer/Controller - Operator's Manual
CELL CAL FACTOR
CAL TRIM C1
CAL TIRM C2
REMOVE CAL TRIM C1
REMOVE CAL TRIM C2
CELL CAL FACTOR
CAL TRIM C1
TDS CVSN FACTOR C2
REMOVE CAL TRIM C1
REMOVE CAL TRIM C2
CELL CAL FACTOR
TDS CVSN FACTOR C1
TDS CVSN FACTOR C2
REMOVE CAL TRIM C1
REMOVE CAL TRIM C2
7/99