Ready-To-Work Indicator - Intermec EasyCoder PM4i User Manual

Chapter 0—Troubleshooting

Ready-to-Work indicator

The readiness of the printer, individually or as a part of a solution, is
indicated by the blue Ready-to-Work (RtW) indicator.
If the Ready-to-Work indicator blinks or is switched off, the printer is
not ready. Further information can be obtained in the display window
by pressing the <F5/i> key. In case of several errors or similar conditions
occurring simultaneously, only the most significant error is displayed.
Once this error has been cleared, next remaining error is displayed.
The printer will also return error messages to the host, provided there is
a working two-way communication. Refer to the Intermec Fingerprint
v8.xx, Programmer's Reference Manual.
Provided the printer is connected to a network, all conditions that pre-
vents printing are reported to the Easy ADC Console. The Easy ADC
Console is a PC-based software which allows a supervisor to monitor all
connected devices that have a Ready-to-Work indicator, including hand-
held computers, access points, and printers.
 Intermec EasyCoder PM4i—User's Guide (Fingerprint version)