Christie Mirage M Series User Manual page 36

Section 2: Installation and Setup
Twin HDMI Input Card
This card accepts one or two HDMI inputs, and can route one or both inputs to the card's outputs. Any input
from any card can be looped out of this card. The output label '1-OUT' loops out the main image being
displayed on the projector. The output labelled '2-OUT' loops out the image displayed in the picture in picture
(PIP). Any input from any optional input card can be looped out of this card. There are 5 LEDs on the module
faceplate. The PWR on the left side indicates power is applied, and that the card is initialized. The LEDs to the
right side of the corresponding connectors indicate that a valid signal is detected. In the case of the output's, the
LED indicates a signal is currently being looped out.
Analog BNC Input Card
This card accepts several types of sync modes. In 5-wire sync mode all 5 BNC connectors are used. If H and V
connectors are swapped, this card will still operate normally. An analog graphic source such as a VGA from a
PC can be connected. The card can operate in 4-wire sync mode, which accommodates 4-wire RGBC sources.
The composite sync cable can be connected to either the H/C BNC or the V BNC. The card supports 3-wire
RGB or YPBPr sync modes, sometimes called sync-on-Green (SOG). In this mode the H/C and V connectors
are not used. The sync is connected to the Green/Y BNC connector. This card offers no loop out capability.
There are 2 LED's on the module faceplate. PWR indicates power has been applied and the card is initialized,
signal indicates a valid signal has been detected.
Dual SD/HD - SDI Input Card
This card accepts both standard-definition (SD) and high-definition (HD) serial-digital-interface (SDI) signals
from 1 of 2 standard-definition (SD) or high-definition (HD) SDI sources. Both single-link HD and dual-link
HD signals are accepted. The card has two SD/HD-SDI outputs, each of which is "loop through" for its
respective input. There are 3 LEDs on the module faceplate. PWR indicates power has been applied and the
card is initialized, and the two signal LEDs indicate a valid signal has been detected on the respective input.
2-22 Mirage M Series User Manual
020-100575-02 Rev. 1 (11-2010)