Christie Mirage M Series User Manual page 120

Section 5: Maintenance
2. To open the lamp door:
Using a Phillips screwdriver turn the 1 captive screw
on the lamp door counter-clockwise to access the
lamp compartment.
the lamps will shut off.
3. Wait
Wait at least 10 minutes before handling the lamps,
to allow the lamps to cool.
4. Remove the old lamp.
a. Unscrew the 3 captive screws securing the lamp using a #1 Phillips screwdriver.
b. Carefully remove the lamp from the projector. Place the old lamp in a location where it cannot fall or
be bumped.
5. To use lamp OFF command:
a. In the lamp menu, select CHANGE LAMP. This will prompt for the old lamp serial number (if it was
not previously entered).
b. Enter the new lamp serial number.
: This action is not mandatory, it is recommended for accurate lamp statistics to be archived.
NOTE
6. Install the new lamp:
a. Take precaution to align the new lamp properly in the correct orientation inside the projector.
b. Press firmly to seat the lamps, ensuring the lamp is secure.
c. Using the Phillips screwdriver and captive screws secure the lamp door and tighten the captive screw.
NOTES: 1)
turned on.
2)
when the door is closed.
5-4
When the door is open,
NOTE:
Handle lamps with extreme caution. Dispose of lamps according to safety regulations
for your area.
If the lamps were turned off with the OFF command in step 1, they will have to be manually
If the lamps were turned off by opening the door, then they will automatically turn on again
F 5-2 R L
IGURE EPLACE AMP
Mirage M Series User Manual
020-100575-02 Rev. 1 (11-2010)