Image Settings Menu - Christie Mirage M Series User Manual

KEEP ASPECT ON AUTO SETUP
Ensures that auto setup for any source will maintain the input aspect ratio when the default size is calculated. If
disabled and the source is not a special case video source where a default stretch is defined, the source is scaled
to fit the platform.
BLANKING - S
This submenu consists of the following options:
• ACTIVE INPUT WINDOW
This read-only value indicates the current size of your displayed data or "region of interest" as defined by the
blanking controls. By default, the projector automatically determines what portion of its full resolution to use,
and pixels in the surrounding borders are turned off. To specify a specific active input window size by adjust
one or more "Blank" settings. For example, if you have blanked (cropped) 100 pixels from both the left and
right edges of an incoming source of 1400 x 1050, the remaining active input window will be reduced to 1200
x 1050.
BLANKING (TOP, BOTTOM, LEFT, and RIGHT)
Crop the image so that unwanted edges are removed from the
display (changed to black). Blanking defines the size of the
Active Input Window, or area of interest. Range of adjustment
depends on the source resolution and other factors.
Blanking a PIP image resembles zoom. For
NOTE:
example, left Blanking zooms the right side of the PIP
image; Right Blanking zooms the left side. There are no
black bars.
NOTE:
3.7

Image Settings Menu

Use the Image Settings menu to alter your main
image without affecting its size or position. Changes
made are applied immediately and are saved when
you exit the menu (press E
not available for the projector model or source are
disabled and appear dim (grey).
CONTRAST
"Contrast" increases or decreases the perceived difference between light and dark areas of your image (0-100).
For best results, keep close to 50. For best results, start with a low value and increase so that whites remain
bright but are not distorted or tinted, and that light areas do not become white.
lighting changes, an adjustment of Gamma is recommended (see below).
Mirage M Series User Manual
020-100575-02 Rev. 1 (11-2010)
UBMENU
PIP function is disabled in 3D mode.
or M
). Options
XIT ENU
F 3-24 B
IGURE LANKING OF A
F 3-25 I S
IGURE MAGE ETTINGS
If the environment
NOTE:
Section 3: Operation
P I
RIMARY MAGE
M
ENU
3-21