Christie Mirage M Series User Manual page 100

Section 3: Operation
9. If your emitter has a reverse setting ensure it is set to the Off position.
10. Set all projectors to 3D Sync Input A (or B) depending on your selection in Step 6 & 7.
11. Apply the 3D test pattern to all projectors.
12. Put on your 3D glasses.
13. When 3D is setup correctly, a small set of L's are visble by closing your right eye and a small set of R's are
visible when closing your left eye.
14. If necessary, adjust the dark interval settings until the test pattern sees the least amount of ghosting for each
projector.
15. Adjust the 3D Sync Delay on the last projector in your array to match the optimal sampling point for the
glasses being used. NOTE: The default auto setup value is typically good for all glasses.
16. Turn off the 3D test pattern on each projector. Your 3D content should look optimal.
3-62 Mirage M Series User Manual
020-100575-02 Rev. 1 (11-2010)