Section 2: Installation and Setup
Input termination (2 Watt, 120 Ohm) is required on the last DMXC card in a loop through configuration. (i.e.
only on the last projector). Termination may be either hardware (by plugging in a termination dongle, etc) or
may be switched in by software, but should not be both. Software termination is only in place when the
projector has AC applied. If there are cases where the network is required to be terminated without AC applied
to the last projector, then a hardware terminator should be used.
Refer to
Section 3 Operation
2-24
for information about setting up the ArtNet and DMX interfaces.
Mirage M Series User Manual
020-100575-02 Rev. 1 (11-2010)