Mounting; Adjusting Projector Height/Tilt - Christie Mirage M Series User Manual

Section 2: Installation and Setup

2.2.3 Mounting

There are several methods for mounting the projector. In typical front and rear screen installations the projector
can be mounted to a secure and level surface, such as a table or cart. Carts are useful when the projector has to
be moved often. Lock the wheels on a cart, when it is in position, to prevent accidental movement during a
presentation.
Ceiling Mount
The projector can be inverted and suspended from the ceiling using a specially designed ceiling mount fixture
118-100108-XX. This mounting is recommended for those that want the projector out of plain view or have
limited amount of space for the projector. For more information, contact your dealer.
Special Mounting
The projector can also be rotated (front-to-back) up to 360 degrees and fixed in a rotated position without
affecting performance. However, the side-to-side tilt limit of the projector must not exceed +/-15 degrees, to
ensure optimal performance of the projector.

2.2.4 Adjusting Projector Height/Tilt

Adjusting Height
You can modify the height of the projector to remedy a slightly uneven mounting surface by adjusting the three
feet threaded into the bottom chassis. Turn each foot clock-wise or counter-clockwise until the projector is
level on all sides.
The front feet are adjusted by turning the collar, see
adjusted. The rear foot is adjusted by turning the entire foot, see
2-10
Only use Christie approved mounts designed for your projector. Refer to the
installation instructions and safety guidelines provided with the mount.
F 2-10 F
IGURE RONT
Figure 2-10 Front Foot.
Figure 2-11 Rear Foot.
F F 2-11 R
OOT IGURE
The front feet do not rotate when
F
EAR OOT
Mirage M Series User Manual
020-100575-02 Rev. 1 (11-2010)