Christie Mirage M Series User Manual page 95

CONNECTING THE 3D STEREO SYNC CABLE
This GPIO cable provides the means for synchronizing the various components in your 3D system. Your
source, projector display output, and emitters or 3D passive filter system can then operate together with
precision to minimize cross-talk and color artifacts. Connect as shown below in
3D Stereo Sync Cable
NOTE: For Mirage M Series models, inputs A and B are not required, but recommended to ensure that stereo
is configured correctly, especially for multiple projector setups.
Connecting Two Stereo 3D Sync Inputs (Recommended for multiple sources). Connect your video card's
stereo 3D sync cable to either Input A or either Input B on the 3D Stereo Sync Cable. These inputs are
provided to allow you to connect two different Stereo 3D sources and conveniently switch the display back-
and-forth between them.
Connecting One Stereo 3D Sync Output Connect the 3D Stereo Sync Cable output to your stereo 3D sync
emitter or 3D passive filter system, PZE device. The L/R switching of the device can then be synchronized
according to the controlling signal of choice—either the source input signal or the projector's internally
generated signal—as set in the projector's 3D Settings menu.
Mirage M Series User Manual
020-100575-02 Rev. 1 (11-2010)
- 3D Stereo Sync Cable.
Figure 43 - Mirage M Series 3D Stereo Sync Cable
Section 3: Operation
Figure 43 - Mirage M Series
3-57