Christie Mirage M Series User Manual page 33

To isolate just RS-422 communications, select "RS-232 and Ethernet Joined". In Figure
Panel, only projector #1 will respond to the RS-422 controller.
To isolate just Ethernet communications, select "RS-232 and RS-422 Joined"—only projector #1 will respond
via Ethernet.
System Integration - GPIO Connector
The GPIO connector on the input panel interface
interfacing a wide range of external I/O devices. Refer to
complete details on pin configuration and how to program the GPIO.
connected for 3D operations.
Mirage M Series User Manual
020-100575-02 Rev. 1 (11-2010)
F 2-22 C
IGURE OMMUNICATING
Figure 2-18 Connecting
F 2-23 I
IGURE NPUT
Section 2: Installation and Setup
T A P
O LL ORTS
RS-422, provides a method of
Appendix B:, Figure B-1- GPIO Connector
The 3D sync cable must be
NOTE:
P
ANEL
Figure 2-23 Input
for
2-19