Christie Mirage M Series User Manual page 73

• NETWORK ROUTING
Not applicable for stand-alone projectors or simple serial networks with only one type of controller
NOTE:
and linking.
Separate - Select "Separate" (factory default) to keep RS-232, RS-422 and Ethernet messages on their
respective paths instead of being broadcast to the other types of ports, refer to
Figure 2-17 Connecting RS-232
RS-232 and RS-422 Joined - Messages originating from an RS-232 or RS-422 controller will be relayed to all
RS-232or RS-422 ports. Any Ethernet communication, however, will not.
RS-232 and Ethernet Joined - Messages to and from the RS-232 ports will also be relayed to the Ethernet
port, and vice versa. Any RS-422 communications will be isolated. In the case of multiple Ethernet sessions
over the single Ethernet connector, input on the RS-232 port will be relayed to all Ethernet sessions; however,
input from any Ethernet session will only be relayed to the RS-232 ports.
All Joined - All messages reach all ports, regardless of type in the case of multiple Ethernet sessions, input on
one Ethernet session will be relayed to all other Ethernet sessions as well as to the RS-232 and RS-422 ports.
ETHERNET SETTINGS - S
Recommended for network administrators only.
NOTE:
• IP ADDRESS
Enter a valid and unique IP address for use on the network to which the projector is currently connected. This
address will overwrite any previous IP address such as the projector's factory-defined default. It takes
approximately 10 seconds for the projector to respond at its new address.
• TCP PORT
On some Ethernet networks, firewall restrictions may require that the port number of the projector be changed
from its default of 3002. If so, enter a new valid port number here. It is highly recommended not to use a port #
below 1000, as these ports are typically reserved for and used by common IP applications.
• SUBNET MASK
Subnet Mask determines the subnet for the IP address and must be set manually.
• DEFAULT GATEWAY
This is the IP address of the gateway used to reach any non-local IP addresses; it must be set manually.
• HOST NAME
Set the hostname for the device
• DOMAIN NAME
Set the domain for the device
• MAC ADDRESS
Displays the MAC address of the projector (read-only)
Mirage M Series User Manual
020-100575-02 Rev. 1 (11-2010)
F 3-30 N
IGURE ETWORK
to Figure 2-22 Communicating To All
UBMENU
R L
OUTING IST
Section 2 Installation and Setup,
Ports.
Section 3: Operation
3-35