Table of Contents
Advertisement
O
PERATION
3 S
From the VFO mode, press and hold in the
one second, and while still holding in the
the DIAL knob to select the bandwidth for the VFO scan-
ner. Release the
frequency. The scanner will stop when it receives a signal
strong enough to break through the Squelch threshold. The
VX-8DR/DE will then hold on that frequency according to
the setting of the "RESUME" mode (Menu Item 83: SCAN
RESUME).
If you wish to reverse the direction of the scan (i.e. toward a lower frequency, instead of a
higher frequency), just rotate the DIAL knob one click in the counter-clockwise direction
while the VX-8DR/DE is scanning. The scanning direction will be reversed. To revert to
scanning toward a higher frequency once more, rotate the DIAL knob one click clock-
wise.
Press the PTT switch briefly to cancel the scanning. See page 60 for more details regard-
ing Scan Operation.
You may initiate upward or downward scanning by pressing and holding
either
scans the bandwidth that was previously selected.
The VX-8DR/DE may receive very strong signals on the Image frequency, and/or
the receiver sensitivity may be somewhat reduced by the combination of the "A-
Band" and "B-Band" frequencies while Dual Receive operation is engaged.
If you experience interference that you suspect may be coming in via an "Image"
path, you may calculate the possible frequencies using the formulas below. This
information may be used in the design of effective countermeasures such as traps,
etc.
9.8304 MHz x
4.9152 MHz x
"A-Band" Freq. = ("B-Band" Freq. ± 46.35 MHz) x
"B-Band" Freq. = ("A-Band" Freq. ± 47.25 MHz) x
"B-Band" Freq. = ("A-Band" Freq. ± 45.8 MHz) x
18
F
key to begin scanning toward a higher
or
key for one second, respectively. In this case, the scanner
Dual Receive Notice
n
11.7 MHz x
n
6.1440 MHz x
N
key for
key, rotate
n
n
(
is an integer: 1, 2, 3, ...)
n
n
n
(@ "A-Band" = NFM)
n
(@ "A-Band" = WFM)
VX-8DR/DE O
M
Advertisement
Table of Contents
