Table of Contents
Advertisement
A
1. Press and hold the
2. Rotate the DIAL knob to select Set Mode Item 17:
BLUETOOTH SET.
3. Press the
key briefly to enable selection of this Set Mode
Item.
4. Rotate the DIAL knob to select the TX/RX switching cir-
cuit of the
VOX: OFF:
VOX: PTT:
VOX: VOX HIGH: Activates the
VOX: VOX LOW: Activates the
Note: When the radio returns to the RX mode from the TX mode while the VOX
feature is activated, the receiving audio output is delayed. This is normal operation.
key, then rotate the DIAL knob to select the
5. Press the
receiver audio output mode of the
parameter is ignored when using the BH-2A
Headset):
MODE: STEREO: Outputs stereo receive audio while listening to the FM Broadcast
MODE: MONO: Outputs monaural receive audio while listening to the FM Broad-
key, then rotate the DIAL knob to select the
6. Press the
Battery Saver function:
SAVE: ON: Activates the Battery Saver in the BH-1A ( or
BH-2A ) .
If there has been no signal or key activity for 20 seconds, the Battery
Saver automatically puts the BH-1A ( or BH-2A ) to "sleep", to conserve
battery life. When a signal is received or the PTT switch is pressed, the
BH-1A ( or BH-2A ) will wakeup and become active again.
Furthermore, if there has been no signal or key activity for 10 minutes,
the BH-1A ( or BH-2A ) will turn off automatically.
SAVE: OFF: Disable the Battery Saver in the BH-1A ( or BH-2A ) .
7. If you wish to turn the
VX-8DR/DE O
key for one second to enter the Set Mode.
function:
Disable the TX/RX switching circuit of
the
function (RX only).
Activates the
Gain: High).
Gain: Low).
band.
Note: When this mode is selected, the VOX function does not work
even if the VOX function is selected in step 4. above. The TX/RX
switching is performed by pressing the PTT switch.
cast band.
M
Bluetooth
function for use with the PTT circuit.
function with the VOX feature (VOX
function with the VOX feature (VOX
unit (this
unit off to conserve transceiver battery power
®
O
PERATION
73
Advertisement
Table of Contents
