Table of Contents
Advertisement
S
CANNING
Memory scanning is also easy to initiate:
1. Set the radio to the Memory Recall ("MR") mode by pressing the
sary.
2. Press and hold in the
key (the current Memory Scan mode will appear on the fre-
quency display) to select the desired Memory Scan mode.
Available selections are ALL CHANNEL, TAG1, TAG2,
BAND, and PMS-X.
ALL CHANNEL: The scanner sweeps all Memory channels.
TAG1:
TAG2:
BAND:
PMS-X:
3. Release the
4. As with VFO scanning, the scanner will halt on any signal encountered that is strong
enough to open the squelch; it will then resume scanning according to the Scan-Re-
sume mode set previously. When there are no memory channels corresponding to the
selected Memory Scan mode, the "MS ERR" notation will appear on the display.
5. To cancel scanning, press the PTT switch or
You may initiate the scanning in the previously selected Memory Scan Mode
by pressing and holding either
64
M
key, then rotate the DIAL knob while holding in the
The scanner sweeps only those Memory channels with the same first
digit of the alpha/numeric tag as the first channel on which scanning
started.
The scanner sweeps only those Memory channels with the same first
and second digits of the alpha/numeric tag as the first channel on
which scanning started.
The scanner sweeps only those Memory channels which are memo-
rized on the same operating band as the first channel on which scan-
ning started.
The scanner will sweep frequencies within the currently-selected PMS
frequency pair. See page 68 for details.
key to start scanning.
S
key.
or
key for one second.
VX-8DR/DE O
key, if neces-
M
Advertisement
Table of Contents
