Table of Contents
Advertisement
I
NSTALLATION OF THE
1. Make sure that the transceiver is off. Remove the hard or soft case, if used.
2. Remove the battery pack.
3. Locate the connector for the BU-2 under the Caution Seal in the battery compartment
on the back of the transceiver, just peel off the Caution Seal (Figure 1).
Cleanly remove the old Caution Seal and adhesive to preserve the submersible per-
formance.
4. Gently install the supplied Connector Unit to the transceiver's connector, then align
the connector on the BU-2 with the connector of the Connector Unit and gently press
the BU-2 into place (Figure 2).
5. Affix the new (supplied) Caution Seal, and replace the battery pack.
6. Installation is now complete.
174
BU-2 O
Figure 1
PTION
BU-2
Connector Unit
Figure 2
VX-8DR/DE O
M
Advertisement
Table of Contents
