Replacing The Glass Gasket And/Or The Glass - Osburn 2000 Installation And Operation Manual

Table of Contents

Advertisement

  2000 Insert Installation and Operation Manual 
 
Place the door face‐down on something soft like a cushion of rags or piece of carpet. Remove the 
old  gasket  from  the  door  by  pulling  and  prying  it  out  with  an  old  screw  driver.  Then  use  the 
screwdriver to scrape the old gasket adhesive from the door. Now run a 1/4" (6 mm) bead of high 
temperature silicone in the door gasket groove. Starting from the middle of the hinge side, press 
the gasket into the groove. Do not stretch the gasket as you place it. Leave the gasket about 1/2" 
long when you cut it and press the end into the groove. Tuck any loose fibres under the gasket and 
into the silicone. Close the door and do not use the insert for 24 hours. 

5.1.4 REPLACING THE GLASS GASKET AND/OR THE GLASS

It is a good idea to replace the glass gasket when the door gasket is replaced. The gasket is flat, 
adhesive‐backed, woven fibreglass. Remove the glass retaining screws and clips. Lift out the glass 
and pull off the old gasket. This is a good time to clean the glass thoroughly. 
 
The gasket must be centred on the edge of the glass. To do this easily, peel back a section of the 
paper covering the adhesive and place the gasket on a table with the adhesive side up. Stick the 
end  of  the  gasket  to  the  middle  of  one  edge,  then  press  the  edge  of  the  glass  down  onto  the 
gasket,  taking  care  that  it  is  perfectly  centred  on  the  gasket.  Peel  off  more  of  the  backing  and 
rotate the glass and press the next section onto the gasket. Do not stretch the gasket as you place 
it. Continue until you get to the start and trim the gasket to length. Now pinch the gasket to the 
glass  in  a  U  shape,  all  around  the  glass.  Reinstall  the  glass,  being  careful  to  centre  the  glass 
carefully  in  the  door.  Do  not  over‐tighten  the  screws.  Note  that  the  two  main  causes  of  broken 
door glass are uneven placement in the door and over‐tightening of retaining screws. 
Do  not  abuse  the  glass  door  by  striking  or  slamming  shut.  Do  not  use  the  stove  if  the  glass  is 
broken. 
  _ _____________________________________________________________________________  2 5 

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

2000 insertOb02011

Table of Contents