Protocol Definition - AudioCodes Mediant 2000 User Manual

SIP User's Manual
Parameter
Serving IP Group ID
[TrunkGroupSettings_ServingIP
Group]
Gateway Name
[TrunkGroupSettings_GatewayN
ame]
Contact User
[TrunkGroupSettings_ContactU
ser]
3.3.5.4

Protocol Definition

The Protocol Definition
parameters. This submenu contains the following page items:

SIP General Parameters (refer to ''

DTMF & Dialing (refer to ''DTMF & Dialing Parameters''
3.3.5.4.1 Configuring SIP General Parameters
The 'SIP General Parameters' page is used to configure general SIP parameters. For a
description of the parameters appearing on this page, refer to ''Configuration Parameters
Reference''
Version 6.0
channels is configured to register Per Gateway, the device
registers all channels except the first four channels. The
channels Group of these four channels
registration request.
The Serving IP Group ID to where INVITE messages initiated
by this Trunk Group's endpoints are sent. The actual destination
to where these INVITE messages are sent is according to the
Proxy Set ID (refer to ''
page 113
URI hostname in the INVITE and REGISTER messages (except
for 'Per Account' registration modes) is set to the value of the
field 'SIP Group Name' defined in the 'IP Group' table (refer to
''Configuring the IP Groups''
If no Serving IP Group ID is selected, the INVITE messages are
sent to the default Proxy or according to the 'Outbound IP
Routing Table' (refer to ''Configuring the Outbound IP Routing
Table''
Note: If the parameter PreferRouteTable is set to 1 (refer to
''Configuring Proxy and Registration Parameters''
the routing rules in the 'Outbound IP Routing Table' prevail over
the selected Serving IP Group ID.
The host name used in the SIP From header in INVITE
messages, and as a host name in From/To headers in
REGISTER requests. If not configured, the global parameter
SIPGatewayName is used instead.
The user part in the SIP Contact URI in INVITE messages, and
as a user part in From, To, and Contact headers in REGISTER
requests. This is applicable only if the field 'Registration Mode'
is set to 'Per Account', and the Registration through the Account
table is successful.
Notes:

If registration fails, then the userpart in the INVITE Contact
header contains the source party number.

The 'ContactUser' parameter in the 'Account Table' page
overrides this parameter.
submenu allows you to configure the main SIP protocol
on page 223 .
Description
Configuring the Proxy Sets Table''
) associated with this Serving IP Group. The Request
on page
on page 142 ).
SIP General Parameters''
99
3. Web-Based Management
sends a single
104 ).
on page
on page 99 )
on page 101 )
March 2010
on
112 ),