Table 3-20: Trunk Group Table Parameters - AudioCodes Mediant 2000 User Manual

SIP User's Manual

To configure the Trunk Group Table:
1. Open the 'Trunk Group Table' page (Configuration tab > Protocol Configuration
menu > Trunk Group submenu > Trunk Group
2. Configure the Trunk Group according to the table below
3. Click the
4. To save the changes to the flash memory, refer to ''
172 .
Parameter
From Trunk
[TrunkGroup_FirstTrunkId]
To Trunk
[TrunkGroup_LastTrunkId]
Channels
[TrunkGroup_FirstBChannel],
[TrunkGroup_LastBChannel]
Version 6.0
Figure 3-57: Trunk Group Table Page
Submit button to save your changes.
Table 3-16: Trunk Group Table Parameters
Starting physical Trunk number in the Trunk Group. The
number of listed Trunks depends on the device's hardware
configuration.
Ending physical Trunk number in the Trunk Group. The
number of listed Trunks depends on the device's hardware
configuration.
The device's Trunk B-channels. To enable channels, enter the
channel numbers. You can enter a range of channels by using
the format [n-m], where
number and m the higher channel number. For example, [1-4]
specifies channels 1 through 4.
Notes:

The number of defined channels must not exceed the
maximum number of the Trunk's B-channels.

To represent all the Trunk's B-channels, enter a single
asterisk (*).
page item).
.
Saving Configuration''
Description
n represents the lower channel
95
3. Web-Based Management
on page
March 2010