Figure 9-14: Proxy Set Id #3 For The Ip-Pbx - AudioCodes Mediant 2000 User Manual

SIP User's Manual
d. In the 'Enable Proxy Keep Alive' drop-down list, select "Using Options" – this is
used in Survivability mode for remote IP-PBX users.
9.2.1.2.5 Step 5: Configure the IP Groups
This step describes how to create the IP Groups for the following entities in the network:

ITSP-A SIP trunk

ITSP-B SIP trunk

IP-PBX

IP-PBX remote users
These IP Groups are later used by the device for routing calls.

To configure the IP Groups:
1. Open the 'IP Group Table' page (Protocol Configuration menu > Proxies,
Registration, IP Groups submenu > IP Group Table
2. Define IP Group #
a. From the 'Type' drop-down list, select 'SERVER'.
b. In the 'Description' field, type an arbitrary name for the IP Group (e.g., ITSP A).
c. From the 'Proxy Set ID' drop-down lists, select '1' (represents the IP addresses,
configured in ,
d. In the 'SIP Group Name' field, enter the host name sent in the SIP Request
From\To headers for this IP Group, as required by ITSP-A (e.g., RegionA).
Version 6.0

Figure 9-14: Proxy Set ID #3 for the IP-PBX

1 for ITSP-A:
for communicating with this IP Group).
433
9. IP Telephony Capabilities
).
March 2010