Table of Contents
Advertisement
Advanced Operation
Commands
#set_udp_remote_port
The #set_udp_remote_port command sets the remote UDP listening port. The default
remote UDP listening port is 50008. The matrix must be rebooted after executing this
command. Use the
#show_udp_remote_port
command to display the current remote
UDP IP address.
Syntax
#set_udp_remote_port param1
Parameters
Port
[0 ... 65535]
param1
Example
#set_udp_remote_port 50008
REMOTE UDP COMMUNICATION PORT 50008 IS SET.
page | 87
- Quick Links:
- Rs-232 and Ip Configuration
Hide quick links:
Advertisement
Table of Contents
